Question Set

1. A network administrator needs to configure a router with a distance-vector protocol that allows classless routing. Which of the following satisfies those requirements?






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.56 am
    In this question, we're calling EIGRP just plain old distance vector. EIGRP is an "advanced" distance-vector routing protocol, sometimes called a hybrid routing protocol because it uses the characteristics of both distance-vector and link-state routing protocols.
Show Similar Question And Answers
QA->An Internet protocol that allows quick file transmission to remote computers is known as:....
QA->Which of the following memories needs refresh?....
QA->Administrator....
QA->Which of the following protocol below are suited for email retrieval?....
QA->A man started to walk East. After moving a distance he turned to his right. After moving a distance he turned to his right again. After moving a little he turned in the end of his left. In which direction he going is now?....
MCQ->A network administrator needs to configure a router with a distance-vector protocol that allows classless routing. Which of the following satisfies those requirements?....
MCQ->Which statement is true regarding classless routing protocols? The use of discontiguous networks is not allowed. The use of variable length subnet masks is permitted. RIPv1 is a classless routing protocol. IGRP supports classless routing within the same autonomous system. RIPv2 supports classless routing.....
MCQ->You get a call from a network administrator who tells you that he typed the following into his router: Router(config)#router ospf 1 Router(config-router)#network 10.0.0.0 255.0.0.0 area 0 He tells you he still can't see any routes in the routing table. What configuration error did the administrator make?....
MCQ->Network 206.143.5.0 was assigned to the Acme Company to connect to its ISP. The administrator of Acme would like to configure one router with the commands to access the Internet. Which commands could be configured on the Gateway router to allow Internet access to the entire network? Gateway(config)# ip route 0.0.0.0 0.0.0.0 206.143.5.2 Gateway(config)# router rip Gateway(config-router)# network 206.143.5.0 Gateway(config-router)# network 206.143.5.0 default....
MCQ->Which two of the following are true regarding the distance-vector and link-state routing protocols? Link state sends its complete routing table out all active interfaces on periodic time intervals. Distance vector sends its complete routing table out all active interfaces on periodic time intervals. Link state sends updates containing the state of its own links to all routers in the internetwork. Distance vector sends updates containing the state of its own links to all routers in the internetwork.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution