Question Set

1. To enable EIGRP, which of the following would you use? Router1(config-if)# ipv6 ospf 10 area 0.0.0.0 Router1(config-if)# ipv6 router rip 1 Router1(config)# ipv6 router eigrp 10 Router1(config-rtr)# no shutdown Router1(config-if)# ipv6 eigrp 10





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.56 am
    Unlike RIPng and OSPFv3, you need to configure EIGRP both from global configuration mode and from interface mode, and you have to enable the command with the no shutdown command.
Show Similar Question And Answers
QA->Correct sentences among the following are: ) The tea is too hot that I cannot drink (2) Work hard, lest you should miss the chance (3) Unless you study well, you will fail (4) Unless you study well, you will pass....
QA->If you scored cannon; which game would you be playing?....
QA->If you scored cannon, which game would you be playing?....
QA->If you had pogonophobia what would you be afraid of?....
QA->If you had Tritonopia what would you not see?....
MCQ->To enable EIGRP, which of the following would you use? Router1(config-if)# ipv6 ospf 10 area 0.0.0.0 Router1(config-if)# ipv6 router rip 1 Router1(config)# ipv6 router eigrp 10 Router1(config-rtr)# no shutdown Router1(config-if)# ipv6 eigrp 10....
MCQ->Network 206.143.5.0 was assigned to the Acme Company to connect to its ISP. The administrator of Acme would like to configure one router with the commands to access the Internet. Which commands could be configured on the Gateway router to allow Internet access to the entire network? Gateway(config)# ip route 0.0.0.0 0.0.0.0 206.143.5.2 Gateway(config)# router rip Gateway(config-router)# network 206.143.5.0 Gateway(config-router)# network 206.143.5.0 default....
MCQ->You get a call from a network administrator who tells you that he typed the following into his router: Router(config)#router ospf 1 Router(config-router)#network 10.0.0.0 255.0.0.0 area 0 He tells you he still can't see any routes in the routing table. What configuration error did the administrator make?....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->Which of the following describe the process identifier that is used to run OSPF on a router? It is locally significant. It is globally significant. It is needed to identify a unique instance of an OSPF database. It is an optional parameter required only if multiple OSPF processes are running on the router.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution