Question Set

1. The configuration register setting of 0x2102 provides what function to a router?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.56 am
    The default configuration setting of 0x2102 tells the router to look in NVRAM for the boot sequence.
Show Similar Question And Answers
QA->If function inside another function is called a _____ Function....
QA->A person who tells the future and interprets character by reading the lines and configuration on the palm....
QA->കമ്പൂട്ടറിന്റെ Register എന്നാലെന്ത്?....
QA->Who is the inventor of Cash Register?....
QA->Which state government has decided to prepare the National Citizen Register (NCR) on the basis of Assam Government?....
MCQ->The configuration register setting of 0x2102 provides what function to a router?....
MCQ->You get a call from a network administrator who tells you that he typed the following into his router: Router(config)#router ospf 1 Router(config-router)#network 10.0.0.0 255.0.0.0 area 0 He tells you he still can't see any routes in the routing table. What configuration error did the administrator make?....
MCQ->Read the following statements as regards register pairs in microprocessor 8085B represents B, C pair with B as high order register and C as low order register.D represents D, E pair with D as high order register and E as low order register.H represents H, L pair with H as high order register and L as low order register. Which of the above statements are correct?....
MCQ->A group of 2m - 1 routers are interconnected in a centralized binary tree, with router at each tree node. Router I communicate with router J by sending a message to the root of the tree. The root then sends the message back down to J. Then find the mean router-router path length.....
MCQ->Network 206.143.5.0 was assigned to the Acme Company to connect to its ISP. The administrator of Acme would like to configure one router with the commands to access the Internet. Which commands could be configured on the Gateway router to allow Internet access to the entire network? Gateway(config)# ip route 0.0.0.0 0.0.0.0 206.143.5.2 Gateway(config)# router rip Gateway(config-router)# network 206.143.5.0 Gateway(config-router)# network 206.143.5.0 default....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution