Question Set

1. Which of the following commands will allow you to set your Telnet password on a Cisco router?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.57 am
    The command line vty 0 4 places you in a prompt that will allow you to set or change your Telnet password.
Show Similar Question And Answers
QA->Correct sentences among the following are: ) The tea is too hot that I cannot drink (2) Work hard, lest you should miss the chance (3) Unless you study well, you will fail (4) Unless you study well, you will pass....
QA->If you have a Power point show you created and want to send using E-mail to another teacher you can add the show to your E-mail message as an______....
QA->Which of these will help you to minimize blurriness that can occur when your camera moves while you take a shot ?....
QA->Where in your body is your patella?....
QA->Where in your body is your patella....
MCQ->Which of the following commands will allow you to set your Telnet password on a Cisco router?....
MCQ->Network 206.143.5.0 was assigned to the Acme Company to connect to its ISP. The administrator of Acme would like to configure one router with the commands to access the Internet. Which commands could be configured on the Gateway router to allow Internet access to the entire network? Gateway(config)# ip route 0.0.0.0 0.0.0.0 206.143.5.2 Gateway(config)# router rip Gateway(config-router)# network 206.143.5.0 Gateway(config-router)# network 206.143.5.0 default....
MCQ->You set the console password, but when you display the configuration, the password doesn't show up; it looks like this: [output cut] Line console 0 Exec-timeout 1 44 Password 7098C0BQR Login [output cut] What cause the password to be stored like this?....
MCQ->You get a call from a network administrator who tells you that he typed the following into his router: Router(config)#router ospf 1 Router(config-router)#network 10.0.0.0 255.0.0.0 area 0 He tells you he still can't see any routes in the routing table. What configuration error did the administrator make?....
MCQ->You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution