Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
Which of the following is known as metal rectifier: ?->(Show Answer!)
Question Set

1. Which of the following is known as metal rectifier:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->The metal known as Rainbow metal?....
QA->The metal known as "Metal of future"?....
QA->The metal known as 'wonder metal'?....
QA->Mercury is transported in metal containers made of which metal?....
MCQ->Consider the following rectifier circuits : half-wave rectifier without filterfull-wave rectifier without filterfull-wave rectifier with series inductance filterfull-wave rectifier with capacitance filter. The sequence of these rectifier circuits in decreasing order of their ripple factor is....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Assertion (A): A half wave controlled rectifier has poorer efficiency and higher ripple factor than a full wave controlled rectifier.Reason (R): The use of a freewheeling diode in half wave controlled rectifier circuit improves the waveform of load current and circuit power factor.

....
MCQ->Pick out thể one word for - a secret arrangement....
MCQ->Which of the following is known as metal rectifier:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution