Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
The metal used for the control spring in an electrical instrument is: ?->(Show Answer!)
Question Set

1. The metal used for the control spring in an electrical instrument is:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which of the following is not a quantitative credit control weapon used by RBI to control credit....
QA->The instrument used to control the resistance?....
QA->Which instrument instrument used for recording earthquake waves?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Which instrument converts mechanical energy into electrical energy?....
MCQ->Match the following: List I (Instrument) List II (Parameters) A.Moving coil galvanometer1.High inertia, soft spring controlB.Ballistic galvanometer2.No control, high dampingC.Vibration galvanometer3.Soft spring control, critical dampingD.Moving coil flux meter4.Low inertia, tuned spring control

....
MCQ->An open coiled helical compression spring 'A' of mean diameter 50 mm is subjected to an axial load W. Another spring 'B' of mean diameter 25 mm is similar to spring 'A' in all respects. The deflection of spring 'B' will be __________ as compared to spring 'A'.....
MCQ->A closely coiled helical spring is acted upon by an axial force. The maximum shear stress developed in the spring is τ . The half of the length of the spring if cut off and the remaining spring is acted upon by the same axial force. The maximum shear stress in the spring in new condition will be....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->The metal used for the control spring in an electrical instrument is:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution