Most frequently used fitting in water supply is: ?->(Show Answer!)

Question Set

1. Most frequently used fitting in water supply is:

Show Similar Question And Answers

QA->Which is the world"s most frequently farmed fish?....

QA->What is meant by ‘Underwriting’; the term frequently used in financial sector?....

QA->What is meant by ‘Underwriting’, the term frequently used in financial sector?....

QA->The two elements that are frequently used for making transistors are?....

QA->Which one of the following occurs more frequently than the other three in the Indian Ocean?....

MCQ->Most frequently used fitting in water supply is:....

MCQ->Statement: In spite of less than normal rainfall in the catchment areas during the first two months of monsoon of the lakes supplying water to the city the authority has not yet affected any cut in the water supply to the city. Assumptions: The rainfall during the remaining part of the monsoon may be adequate for normal water supply. The present water level of the lakes supplying water to the city may be adequate for normal supply.

MCQ->Statement: The meteorological department has issued a notification forecasting less rainfall during next year's monsoon. Courses of Action: The government should immediately set up a water authority for proper management of water resources. The water supply authorities should be asked to implement reduction in regular water supply to tackle the situation. The farmers should be advised to cultivate alternate crops which require less water during the coming months.

MCQ->Statement: The residents of the locality wrote a letter to the Corporation requesting to restore normalcy in the supply of drinking water immediately as the supply at present is just not adequate. Assumptions: The Corporation may not take any action on the letter. The municipality has enough water to meet the demand. The water supply to the area was adequate in the past.

MCQ->Pressure drop due to pipe fittings can be estimated by the equation, , where, Le = equivalent length of straight pipeline which will incur the same frictional loss as the fitting and D = diameter of the fitting. The value of (dimensionless) for 45° elbow and 180° close return bends would be respectively around....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution