Question Set

1. In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A man is facing South. He turns 1350 in the anti clockwise direction and then 1800 in the clockwise direction. Which direction is he facing?....
QA->The Direct Tax Code (DTC) task force has recommended a major cut in corporate tax for both domestic and foreign companies. What is the newly recommended corporate tax rate for both domestic and foreign companies?....
QA->Arjun walks 2 kms northwards and then he turns right and moves 3 kms. He again turns right and goes 2 kms and turns his left and starts walking straight. In which direction he is walking now ?....
QA->Arjun walks 2 kms northwards and then he turns right and moves 3 kms. He again turns right and goes 2 kms and turns his left and starts walking straight. In which direction he is walking now ?....
QA->A line that indicates equal or constant pressure on a map is called ____?....
MCQ->In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:....
MCQ->Consider the following statements relating to hydraulic gradient line and energy gradient line 1. In the case of a fluid flowing in a pipeline, hydraulic gradient line and energy gradient line may coincide. 2. The line joining the points representing piezometric heads is known as hydraulic gradient line. 3. In the case of ideal fluid, energy gradient line is always horizontal. 4. Hydraulic gradient line has a downward slope in the case of flow through pipes. Of these statements :....
MCQ->Which of the following statements are correct about datatypes in C#.NET? Every datatype is either a value type or a reference type. Value types are always created on the heap. Reference types are always created on the stack. Mapping of every value type to a type in Common Type System facilitates Interoperability in C#.NET. Every reference type gets mapped to a type in Common Type System.....
MCQ->The "Back sight" reading on a vertically held staff at a point A on the floor along the centre line of a railway tunnel is 3.465 m, and the "Fore sight" on the inverted staff held at the roof of the tunnel just vertically above A is 1.115 m. The height of the tunnel along the centre line at floor point A is....
MCQ->The arrow points on either end of a Cutting Plane line indicate the direction of view.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution