Question Set

1. This is used to indicate that a surface is to be machined:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->ഇന്ത്യയുടെ ഭൂതല-ഭൂതല ( surface to surface) മിസൈൽ?....
QA->When yellow light is incident on a surface no electrons are emitted while green light can emit. If the red light is incident on the surface then?....
QA->What does the rise of mercury in a barometer indicate?....
QA->Which colour types do not indicate fair or fine weather?....
QA->What does lattitude place indicate?....
MCQ->This is used to indicate that a surface is to be machined:....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface : 1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area. 2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface. 3. The resultant force on a curved surface acts on the bottom of th6 curved surface. Of these statements :....
MCQ->The angle which is found between the face of the cutting tool and the normal to the machined surface at the cutting edge is called:....
MCQ->The angle between the face of the tool and a line tangent to the machined surface at the cutting point is called cutting angle.....
MCQ->The surface to be machined is marked on the pattern by....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution