Question Set

1. When laying out a gear, the number of spaces should be twice the number of teeth.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In an automobile gear transmission the counter shaft drive gear is meshed with the gear on the:....
QA->Which shortcut key is used for underlines words but not spaces?....
QA->Which of the following is egg laying mammal ?....
QA->Out of gear....
QA->What is the total number of permanent teeth in an adult ?....
MCQ->When laying out a gear, the number of spaces should be twice the number of teeth.....
MCQ->A fixed gear having 200 teeth is in mesh with another gear having 50 teeth. The two gears are connected by an arm. The number of turns made by the smaller gear for one revolution of arm about the centre of bigger gear is....
MCQ->If T is the actual number of teeth on a helical gear and φ is the helix angle for the teeth, then formative number of teeth is written as....
MCQ->Gear A has a weight of 1.5 lb, a radius of 0.2 ft, and a radius of gyration of ko = 0.13ft. The coefficient of friction between the gear rack B and the horizontal surface is = 0.3. If the rack has a weight of 0.8 lb and is initially sliding to the left with a velocity of (vB)2 = 8 ft/s to the left. Neglect friction between the rack and the gear and assume that the gear exerts only a horizontal force on the rack.....
MCQ->For a bevel gear having the pitch angle θ , the ratio of formative number of teeth (TE) to actual number of teeth (T) is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution