Question Set

1. Direct shell production casting is used in directly creating molds for metal casting.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Name the alloy used for casting engine parts?....
QA->A company produces 18% more machines than of the previous year. If their production in the current year is 17700 machines, the production last year is :....
QA->A company exports 18% more products than previous year. If production in the current year is 17700 then, what was the production previuos year?....
QA->The hydraulic brakes used in automobiles is a direct application of which law?....
MCQ->Direct shell production casting is used in directly creating molds for metal casting.....
MCQ->Grains spoiled by molds are a potential animal or human health hazard as well as a great economic loss. Which is/are the common species of molds in the spoilage of stored grains by molds?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Solidification time of a molten metal in a casting is proportional to (where, V = volume of metal & A = its surface area ; in the casting)....
MCQ->Statement: The integrated steel plants in India would no longer have to depend on imports for continuous casting refractories. Assumptions: Continuous casting refractories are needed by India. Continuous casting refractories are in demand.

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution