Question Set

1. Circles, circular arcs, and other curved surfaces may be drawn using offset measurements.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A transparent medium bounded by two surfaces atleast one of which is curved surface is called?....
QA->The name of te scheme to provide Health insurance to poor (BPL), Domestic workers, MGNERGA workers, Rikshawpullers, Building and other construction workers, and many other categories as may be identified by the respective states?....
QA->Two trains are 2 km apart and their lengths are 200 m and 300 m. They are approaching towards each other with a speed of 20 m/s and 30 m/s respectivety. after how much time they cross each other....
QA->A cheque may be drawn for a maximum period of:....
QA->The process where the inner pages of a section is deliberately printed offset slightly towards spine fold ?....
MCQ->Circles, circular arcs, and other curved surfaces may be drawn using offset measurements.....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface : 1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area. 2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface. 3. The resultant force on a curved surface acts on the bottom of th6 curved surface. Of these statements :....
MCQ->Consider the following assumptions of Bowditch method : 1. Angular measurements are more precise than linear measurements. 2. Linear measurements are more prescise than angular measurements. 3. Erros in linear measurements are proportional to L . 4. Correction to latitude or departure of any side = Total error in L (or D) x Length of that side / Perimeter of traverse. Which of these statements are correct ?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Statements : Some circles are rectangles. All squares are rectangles. Conclusions : Atleast some squares are circles. All rectangles are circles.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution