Datum surfaces and features are used as references to control other features. ?->(Show Answer!)

Question Set

1. Datum surfaces and features are used as references to control other features.

Ask Your Doubts Here

Comments

Show Similar Question And Answers

QA->Which of the following is not a quantitative credit control weapon used by RBI to control credit....

QA->Two trains are 2 km apart and their lengths are 200 m and 300 m. They are approaching towards each other with a speed of 20 m/s and 30 m/s respectivety. after how much time they cross each other....

QA->The name of te scheme to provide Health insurance to poor (BPL), Domestic workers, MGNERGA workers, Rikshawpullers, Building and other construction workers, and many other categories as may be identified by the respective states?....

QA->A program that has capability to infect other programs and make copies of itself and spread into other programs is called:....

MCQ->Datum surfaces and features are used as references to control other features.....

MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....

MCQ->Which two statements are true about wrapper or String classes? If x and y refer to instances of different wrapper classes, then the fragment x.equals(y) will cause a compiler failure. If x and y refer to instances of different wrapper classes, then x == y can sometimes be true. If x and y are String references and if x.equals(y) is true, then x == y is true. If x, y, and z refer to instances of wrapper classes and x.equals(y) is true, and y.equals(z) is true, then z.equals(x) will always be true. If x and y are String references and x == y is true, then y.equals(x) will be true.....

MCQ->If s1 and s2 are references to two strings, then which of the following is the correct way to compare the two references?....

MCQ->Which of the following statements are correct? The switch statement is a control statement that handles multiple selections and enumerations by passing control to one of the case statements within its body. The goto statement passes control to the next iteration of the enclosing iteration statement in which it appears. Branching is performed using jump statements which cause an immediate transfer of the program control. A common use of continue is to transfer control to a specific switch-case label or the default label in a switch statement. The do statement executes a statement or a block of statements enclosed in {} repeatedly until a specified expression evaluates to false.....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution