Increased precision makes parts less expensive to manufacture. ?->(Show Answer!)

Question Set

1. Increased precision makes parts less expensive to manufacture.

Show Similar Question And Answers

QA->Which element on adding to natural rubber makes it less sticky in hot weather and less hard in cold weather?....

QA->An electronic device makes a beep after 60 sec.Another device makes a beep after ever 62sec.They beeped together at 10am.The time when they will next make a beep together at the earliest,is....

QA->If a number is increased by 30% and then from the increased number its 30% is decreased. Then :....

QA->If the diameter of a circle is increased by 100%, its area is increased by :....

QA->At his usual rowing rate, Rahul can travel 12 miles downstream in a certain river in 6 hrs less than it takes him to travel the same distance upstream. But if he could double his usual rowing rate for this 24 mile round trip, the downstream 12 miles would then take only one hour less than the upstream 12 miles. What is the speed of the current in miles per hour?....

MCQ->Increased precision makes parts less expensive to manufacture.....

MCQ->If a 30 m length can be taped with a precision of ± 0.01 m, then the standard error of measuring 1.08 km with the same precision will be....

MCQ->Right to information is the most effective and innovative tool in Indian administration because: (i) it accepts people's rights and privileges to know. (ii) it makes political system accountable and transparent. (iii) it makes people aware of public policies and decision making. (iv) it makes administrative more innovative. ....

MCQ->A mild steel bar is in three parts, each 20 cm long. The diameters of parts AB, BC and CD are 2 cm, 1 cm and 3 cm respectively. The bar is subjected to an axial pull of 4t as shown in the given figure. If E = 2 x 106 kg/cm2 and the elongations in the three parts of the bar are Δ1, Δ2 and Δ3 respectively, then the ratio of the greatest to the least of these elongations will be

MCQ->A long helical spring having a spring stiffness of 12 kN/m and number of turns 20, breaks into two parts with number of turns 10 each in both the parts. If the two parts are connected in series, then the softness of the resultant spring will be....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution