Question Set

1. Longitudianl cracks observed in timber beams are due to





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A glass container cracks when very hot tea is poured into it. A probable reason for this is the?....
QA->Travancore Timber Products is located at?....
QA->One of the most important centres in the world for timber business?....
QA->The copper compound used for preserving timber and hides is?....
QA->Pine; fir; spruce; cedar; larch and cypress are the famous timber-yielding plants of which several also occur widely in the hilly regions of India. All these belong to?....
MCQ->Longitudianl cracks observed in timber beams are due to....
MCQ->Which of the following pairs regarding the defects in timber are correctly matched ? 1. Upsets....due to overmaturity and unventilated star age of wood. 2. Fwciness....due to crushing of fibres running transversel. 3. Star shakes....radial splits widest at the circumference and diminishing towards the centre. 4. Heart shakes....cracks widest at the centre and diminishing towards the outer circumference. Select the correct answer using the codes given below.....
MCQ->Two simply supported beams B1 and B2 have spans l and 2l respectively. Beam B1 has a cross-section of 1 x 1 units and beam B2 has a cross-section of 2 x 2 units. These beams are subjected to concentrated loads W each at the centre of their spans. The ratio of the maximum flexural stress in these beams is....
MCQ->Consider the following statements : The use of relatively weak motor 1. will accommodate movements due to loads, cracking if any and will be distributed as thin hair cracks which are less noticeable or harmful. 2. will result in reduction of stresses due to differential expansion of masonry units. Of these statements :....
MCQ->A timber beam of rectangular section 100 mm x 50 mm is simply supported at the ends, has a 30 mm x 10 mm steel strip securely fixed to the top surface as shown in the given figure. The centroid of the "Equivalent timber beam" in this case from the tope surface ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution