79702. Geometric primitives include shapes such as ________.
79703. Panel discussion involves
79704. A full scale technical drawing will have a scale factor of ________.
79705. Anti sterility vitamin is
79706. If technical drawings are used to communicate size and shape descriptions, it is not important to worry about either the weight of a line or the type of line being used.
79707. An expert committee for health man power planning,production and management is known as
79708. The ASME Y14.2M line thickness standard for visible lines is .8mm thick.
79709. Erogtism occurs due to
79710. A projection plane is an imaginary 2 dimensional plane that needs to be parallel to the surface of the object.
79711. The study of anthropoids which are of medical importance is known as
79712. A "D" size architectural sheet measures 24" X 36".
79713. Angular stomatitis is caused by
79714. In a set of architectural drawings the views illustrating the front, back, and side of a house are called elevations.
79715. ESI Act was enforced by the Government in
79716. A visible line represents the continuous edge of an object being illustrated.
79717. MMR vaccine given at the month of
79718. A three dimensional object can be constructed with only the height and width dimensions given.
79719. Slow sand or biological filtration of water is introduced in Scotland in
79720. Short dashed lines can be used to illustrate a visible feature.
79721. Orthotolidine test was developed in:
79722. Multi-view drawings are usually comprised of the projected views which illustrate the height, width, and depth of an object.
79723. The instruments devised for measuring the cooling power of the air is:
79724. The projection of geometric information such as lines, points, and planes is usually referred to as orthographic projection.
79725. Clark’s process is a method of removing
79726. If a designer is developing a plan for a project in which the entire part is made out of ¾" thick plywood and he only wants to use one view, he should use the ________ view.
79727. CARE began its operation in India in
79728. In developing a multi-view drawing the drafter can use a ________ line to help locate the top and right side views.
79729. Un International torts except
79730. The type of line that projects from an object for the express purpose of locating a dimension is a ________ line.
79731. AUGER is required in construction of
79732. Center lines are used to locate or represent the centers of ________.
79733. First feferral unit for PHC is
79734. Architectural drawings used to construct a house are often plotted with a scale of ¼" = 1'-0". What scale is this?
79735. ORS contains all except
79736. Oblique sections are useful to show this:
79737. The headquarters of FAO
79738. In oblique projections, the projectors are perpendicular to each other but are not parallel to the plane of projection.
79739. The following one is the trace elements of mineral
79740. Circles, circular arcs, and other curved surfaces may be drawn using offset measurements.
79741. The freshness of the eggs may be tested by
79742. In general, all types of sections for isometric drawing may be applied to oblique drawing.
79743. The borehole latrine is introduced in India in
79744. In an oblique drawing, when an angle is specified in degrees in a receding plane, you should convert the angle into circular measurements.
79745. In the hard ticks the dorsum of its body is covered by a hard shield is called
79746. In CAD, oblique drawings are difficult to create because you cannot use snap increments or draw similarly to drawing on grid paper.
79747. The instrument used for measuring humidity
79748. If a complicated pictorial is needed, it may be easier and more accurate to create a 3D model than an oblique drawing.
79749. Three gram of fat gives
79750. If you are sketching an ellipse in an oblique drawing, you can block in the enclosing rectangle and sketch the ellipse tangent to its sides.