1. A colloid formed between gas particles and liquid or solid particles?

Answer: Foam

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A colloid formed between gas particles and liquid or solid particles?....
QA->Colloid which contains particles of liquid or solid dispersed in gas?....
QA->A​ ​white​ ​solid’A’on​ ​heating​ ​gives​ ​off​ ​a​ ​gas​ ​which​ ​turns​ ​lime​ ​water milky.The​ residue​ ​is​ ​yellow​ ​when​ ​hot​ ​but​ ​turns​ ​white​ ​on​ ​cooling​ ​.The solid​ ​A​ ​is:....
QA->The only matter which exists in three forms (Solid; liquid; gas)?....
QA->If a liquid wets a solid surface; what is the angle of contact?....
MCQ->200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 x 10-3 kg/m2.s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m2/1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid)...
MCQ->Consider the following statements : In solid waste management 1. density separation of solid wastes can be accomplished by air classifiers. 2. iron recovery from solid wastes can be done by magnetic separators. 3. aluminium separation from solid wastes can be accomplished by eddy current separators. Which of the statements given above are correct ?...
MCQ->Number of particles in a crushed solid sample is given by (where, m = mass of particles in a sample, Vp = volume of one particle, ρ= density of particles)...
MCQ->Experiments were conducted to determine the flux of a species A in a stagnant medium across a gas-liquid interface. The overall mass transfer co-efficient based on the liquid side for dilute systems for the above was estimated to be 4 x 10-3 kg mole/m2.s. The equilibrium data for the system is given as y = 2x. The flux across the interface (in kg mole/m2 .s) for bulk concentrations of A in gas phase and liquid phase as y = 0.4 and x = 0.01 respectively is...
MCQ->Assertion (A): In liquid system the ratio of change in liquid level to change in flow rate is called resistance of liquid flow.Reason (R): In liquid level systems the ratio of change in liquid stored in a tank to the change in head is called capacitance of tank.

...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution