The metal having highest density? ?->(Show Answer!)

1. The metal having highest density?

Answer: Osmium

Tags

Show Similar Question And Answers

QA->The metal having highest density?....

QA->The non-metal having highest density?....

QA->Which metal has the highest density?....

QA->The metal having highest boiling point?....

QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....

MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...

MCQ->The relative density of a soil having maximum dry density rd(max)=2 minimum dry density 2 and normal density is 6:...

MCQ->Consider the following statements : 1. The standard penetration test is a reliable method for measuring the relative density of granular soils. 2. For a sand having the same relative density, N-values remain the same at all depths. 3. For a sand having the same relative density, N-values are different at different depths. Which of the statements given above is/are correct ?...

MCQ->Pick out thể one word for - a secret arrangement...

MCQ->A metal pipe of 1 m diameter contains a fluid having a pressure of 1 N/mm2. If the permissible tensile stress in the metal is 20 N/mm2, then the thickness of the metal required for making the pipe will be...

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution