Substance added to ore to remove impurities is known as? ?->(Show Answer!)

1. Substance added to ore to remove impurities is known as?

Answer: Flux

Tags

Show Similar Question And Answers

QA->Substance added to ore to remove impurities is known as?....

QA->The substances added to ore to remove impurities is called:....

QA->Heating the ore below its melting point in the absence of air I to remove volatile impurities is known as?....

QA->The method of concentrating the ore which makes use of the difference in density between ore and impurities is called?....

QA->The earthy impurities present in the ore are called?....

MCQ->The treatment of the ore with suitable reagents which can selectively dissolve the ore but not the impurities, is known as...

MCQ->The method of concentrating the ore which makes use of the difference in density between ore and impurities is called...

MCQ->Frother is added in the froth floatation cell used in ore beneficiation to stabilise the air bubbles (i.e., froth), which will hold the ore particles, but it does not affect the floatability of minerals. Which of the following is not used as a frother?...

MCQ->If the ore impurities is...

MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution