Simplest atom (based on atomic mass) is that of? ?->(Show Answer!)

1. Simplest atom (based on atomic mass) is that of?

Answer: Hydrogen

Tags

Show Similar Question And Answers

QA->Simplest atom (based on atomic mass) is that of?....

QA->What is the number of electrons in an atom of atomic number Z and mass number A?....

QA->The simplest atom is?....

QA->Simplest Radioactive atom is?....

QA->The scientist who classified elements based on Atomic Values is?....

MCQ->What is the simplest formula of a compound containing 50% of element A (atomic weight = 10) and 50% of element B (atomic weight = 20) ?...

MCQ->The atomic mass of an element is the number of times the atom of that element is heavier than the hydrogen atom....

MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...

MCQ->The atomic weight and atomic number of an element are A and Z respectively. What is the number of neutrons in the atom of that element ?...

MCQ->The correlation often employed to correlate adsorption data for protein is (where Ymax is the maximum amount of solute adsorbed per mass of adsorbent, X is the mass fraction of solute in the diluent phase in solute-free basis, KL is a constant and Y is the equilibrium value of the mass of solute adsorbed per mass of adsorbent)...

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution