1. Metal used for the manufacture of aeroplane?

Answer: Titanium

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Metal used for the manufacture of aeroplane?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->..... is used to detect the direction and range of an approaching aeroplane by means of radio microwaves.?....
QA->Which fuel is used in aeroplane?....
QA->Fisher-Tropsch process is used in the manufacture of which liquid?....
MCQ->The engine of an aeroplane rotates in clockwise direction when seen from the tail end and the aeroplane takes turn to left.The effect of gyroscopic couple on the aeroplane will be:...
MCQ->The engine of an aeroplane rotates in clockwise direction when seen from the tail end and the aeroplane takes a turn to the right. The effect of gyroscopic couple on the aeroplane will be to dip the nose and raise the tail....
MCQ->The engine of an aeroplane rotates in clockwise direction when seen from the tail end and the aeroplane takes a turn to the left. The effect of gyroscopic couple on the aeroplane will be...
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...
MCQ->An aeroplane flies 600 km in 20 minutes then the speed of aeroplane is...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution