Oxidation state of iron in hemoglobin is? ?->(Show Answer!)

1. Oxidation state of iron in hemoglobin is?

Answer: 2

Tags

Show Similar Question And Answers

QA->Oxidation state of iron in hemoglobin is?....

QA->One molecule of hemoglobin can carry how many atom of oxygen?....

QA->Which is the compound in that oxygen shows + oxidation state?....

QA->Select the compound in which chlorine shows oxidation state + ?....

QA->Which is an element which never exhibits positive oxidation state in any of its compounds?....

MCQ->Oxidation state of iron in hemoglobin is?...

MCQ->Which of the following pairs are correctly matched ? 1. Alpha iron....non magnetic 2. Beta iron....strongly magnetic 3. Gamma iron....non-magnetic and capable of dissolving carbon. 4. Delta iron....non-magnetic and absorbs very little carbon. Select the correct answer using the codes given below :...

MCQ->Consider the following statements : In water supply distribution network, 1. the grid-iron system requires more length of pipe lines and larger number of cut-off valves. 2. the design of the grid-iron system is difficult but economical. 3. employing a grid-iron system, the dead ends are completely eliminated. 4. employing a grid-iron system permits more water to be diverted towards the affected point from various directions. Which of the statements given above are correct ?...

MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...

MCQ->The mineral which aids in the utilization of iron and in hemoglobin synthesis is...

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution