1. A circular disc of copper has a symmetrical hole at its center. The disc is uniformly heated. The diameter of the hole will?

Answer: Increase

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A circular disc of copper has a symmetrical hole at its center. The disc is uniformly heated. The diameter of the hole will?....
QA->A metal plate with a circular hole at the centre is heated. What will happen to the area of the hole?....
QA->A metal sheet with circular hole is heated. what change will be in the hole?....
QA->A metal sheet with a circular hole is heated. The hole will?....
QA->What does mixture of CS2 and H2 S on passing over heated copper give?....
MCQ->A circular disc of copper has a symmetrical hole at its center. The disc is uniformly heated. The diameter of the hole will?...
MCQ->A circular hole of 50 mm diameter is cut out from a circular disc of 100 mm diameter as shown in the below figure. The centre of gravity of the section will lie ...
MCQ->The extension of a circular bar tapering uniformly from diameter d1 at one end to diameter d2 at the other end, and subjected to an axial pull of P is __________ the extension of a circular bar of diameter d1 d2 subjected to the same load P....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...
MCQ->A shaft has an attached disc at the centre of its length. The disc has its centre of gravity located at a distance of 2 mm from the axis of the shaft. When the shaft is allowed to vibrate in its natural bow-shaped mode, it has a frequency of vibration of 10 rad/s. When the shaft is rotated at 300 r.p.m., it will whirl with a radius of...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions