Which metal is not used as electro magnet? ?->(Show Answer!)

1. Which metal is not used as electro magnet?

Answer: Copper

Tags

Show Similar Question And Answers

QA->Which metal is not used as electro magnet?....

QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....

QA->Which metal is used for making boats because it does not corrode by seawater?....

QA->“Ask not, Say not, think not caste” are the words of?....

QA->“ Liquor is poison, make it not, sell it not, drink it not” are the words of?....

MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...

MCQ->Match the following: List I List II A.Electro-encephalograph1.Diagnostic tool for heart ailmentB.Electro-cardiograph2.Diagnostic tool for brain ailmentC.Sphygmomanometer3.used for measuring BPD.Stethoscope4.used to heart pulse/ heart beat

MCQ->In household energy meters the flux of series magnet is in phase with current but the flux of shunt magnet lags the voltage by 88°. The reading of energy meters...

MCQ->If φsh is flux of shunt magnet, φse is flux of series magnet, ish is eddy current due to φse, the torque in an induction wattmeter is proportional to...

MCQ->A magnet of pole strength m is divide into four equal parts so that the length as well as the breadth of each part is half of the original magnet. Then pole strength of each part is...

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution