1. Which metal is used for making boats because it does not corrode by seawater?

Answer: Titanium

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Which metal is used for making boats because it does not corrode by seawater?....
QA->Which metal is commonly used for making an electromagnet?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Which pair does not contain a coinage metal?....
QA->The metal which does not allow X-ray to pass through?....
MCQ->Statements: All poles are guns. Some boats are not poles. Conclusions: All guns are boats. Some boats are not guns.

...
MCQ->Statements: All roads are waters. Some waters are boats. Conclusions: Some boats are roads. All waters are boats.

...
MCQ->Statements: Some bricks are trees. All trees are pens. All pens are boats. Conclusions: Some boats are bricks. Some pens are bricks. Some trees are bricks. Some bricks are boats.

...
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...
MCQ->Consider the following statements in respect of plate girders : 1. A large number of cover plates are provided over flange angles so that curtailed flanges match the bending moment diagram exactly. 2. At least one cover plate should extend over the entire span so that rain water may not enter and corrode the connections. 3. A minimum of one-third of flange area should be provided in flange angles and balance in flange cover plates for stability. Which of the statements given above are correct ?...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution