1. Which metal is commonly used for making an electromagnet?

Answer: Iron

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which metal is commonly used for making an electromagnet?....
QA->Which are the most commonly used chemicals in the artificial rain making or cloud seeding?....
QA->Which metal is used for making boats because it does not corrode by seawater?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->The metal used for making IC Chips?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...
MCQ->Which metal is commonly used for making an electromagnet?...
MCQ->A metal pipe of 1 m diameter contains a fluid having a pressure of 1 N/mm2. If the permissible tensile stress in the metal is 20 N/mm2, then the thickness of the metal required for making the pipe will be...
MCQ->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?...
MCQ->Neoprene which is used for making shoe heels & belts is superior to natural rubber in its stability to aerial oxidation and resistance to oils & other solvents. The monomer used for making neoprene is...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution