1. What does mixture of CS2 and H2 S on passing over heated copper give?

Answer: Methane

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->What does mixture of CS2 and H2 S on passing over heated copper give?....
QA->A magnet made by binding insulated copper wire over a soft iron piece and passing an electric current through the wire is called?....
QA->The metal used to recover copper from a solution of copper sulphate is?....
QA->A circular disc of copper has a symmetrical hole at its center. The disc is uniformly heated. The diameter of the hole will?....
QA->In a bid to fill the vacant seats in trains and meet the challenges posed by the roadways and airways, the Indian Railways has decided to give discount of up to __________ to passengers on ticket fares in air-conditioned executive class and chair cars of trains like Shatabdi Express, Gatiman Express, Tejas Express, Double Decker and Intercity Express.....
MCQ->A jar contains a mixture of milk and water in the respective ratio of 3:1. When 4 litre of the mixture is taken out and thereafter 3 litre of milk is added to the remaining mixture. The respective ratio of milk and water in the resultant mixture thus formed is 4:1. What was the initial quantity of water in the mixture...
MCQ->Match Column A with Column B and select the correct answer from the codes given below : Column A (Phrasal verbs) Column B (Meanings) a.give away 1.resign b.give over 2.transfer c.give up 3.pronounce d.give off 4.abandon 5.emit...
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...
MCQ->If a composite bar of steel and copper is heated, then the copper bar will be subjected to...
MCQ->A bar of copper and steel form a composite system, which is heated to a temperature of 40°C. The stress induced in the copper bar will be...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions