1. Where was the first iron and steel industry of India established?

Answer: Jamshedpur

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Where was the first iron and steel industry of India established?....
QA->Bhadravati, famous for Iron and steel industry, is in the state of?....
QA->India’s first large scale steel plant in private sector was established at?....
QA->Why a ship of iron and steel float on water?....
QA->Stainless Steel ഉണ്ടാക്കാൻ Steel ൻ്റെകുടെ ചേർക്കുന്ന ലോഹം....
MCQ->Which of the following pairs are correctly matched ? 1. Alpha iron....non magnetic 2. Beta iron....strongly magnetic 3. Gamma iron....non-magnetic and capable of dissolving carbon. 4. Delta iron....non-magnetic and absorbs very little carbon. Select the correct answer using the codes given below :...
MCQ->Consider the following statements : In water supply distribution network, 1. the grid-iron system requires more length of pipe lines and larger number of cut-off valves. 2. the design of the grid-iron system is difficult but economical. 3. employing a grid-iron system, the dead ends are completely eliminated. 4. employing a grid-iron system permits more water to be diverted towards the affected point from various directions. Which of the statements given above are correct ?...
MCQ->Pick out thể one word for - a secret arrangement...
MCQ->In India, iron and steel industry made its beginning in 1870. The first factory was set up at:?...
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution