1. Non-stick cooking utensils are coated with which metal?

Answer: Teflon

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Non-stick cooking utensils are coated with which metal?....
QA->Non stick cooking utensils are coated with?....
QA->Non - stick kitchen wares are coated with?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->The venue of the annual session of Indian National Congress in 1920 in which the resolution on Non-Cooperation was repeated again and the non-cooperation movement was endorsed?....
MCQ->Fact 1: Some pens don't write. Fact 2: All blue pens write. Fact 3: Some writing utensils are pens. If the first three statements are facts, which of the following statements must also be a fact? I: Some writing utensils don't write. II: Some writing utensils are blue. III: Some blue writing utensils don't write....
MCQ->Non stick cooking utensils are coated with...
MCQ->Non stick cooking utensils are coated with?...
MCQ->Non-stick cooking utensils are coated with : -Fireman Trainee, Assistant Time Keeper (2009)...
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution