1. Aranmula a major attraction for its famous metal mirrors and snake boat race is in?

Answer: Pathanamthitta district

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Aranmula a major attraction for its famous metal mirrors and snake boat race is in?....
QA->Aranmula is a major attraction for its famous?....
QA->Which is the first boat race in Kerala which marks the beginning of the season of boat race in Kerala?....
QA->Aranmula Uthratathi Boat race is held in?....
QA->On a stationary sail boat, air is blown from a fan attached to the boat. The boat?....
MCQ->Boat A travels upstream from point X to point Y in 2 hours more than the time taken by Boat B to travel downstream from point Z to point Y. The distance between X and Y is 40 km and the distance between Y and Z is 24km. The speed of Boat A in still water is equal to the speed of Boat B downstream. What is the speed of Boat A in still water ? (Consider the speed of the current to be the same.)...
MCQ->Statements:All dials are mirrors.All mirrors are spoons.Some spoons are decks.Some decks are chairs. Conclusions:I. Some decks are mirrors.II. Some spoons are dials.III. Some decks are dials.IV. Some chairs are spoons....
MCQ->The speed of a boat in still water is 16km/h and the speed of the current is 2 km/h. The distance travelled by the boat from point A to point B downstream is 12 km more than the distance covered by the same boat from point B to point C upstream in the same time. How much time will the boat take to travel from C to B downstream...
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...
MCQ->Which is the first boat race in Kerala which marks thebeginning of the season of boat race in Kerala:...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution