1. The rays Used to fill inside the tube lights is?

Answer: Ultraviolet Rays

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The rays Used to fill inside the tube lights is?....
QA->Gases used to fill inside a filament lamp?....
QA->Let a thin capillary tube be replaced with another tube of insufficient length then, we find water?....
QA->------------type of reflector used for automobile head lights is:....
QA->The rays Used to disinfect equipment used for operation is?....
MCQ->Statements: Some taxis have horns. Some taxis have lights. Conclusions: Every taxi has either horn or light. Some taxis have neither light nor horn. Some taxis have horns as well as lights. No taxi has horn as well as light.

...
MCQ->The inside heat transfer co-efficient in case of turbulent flow of liquid in the tube side in a 1-2 shell and tube heat exchanger is increased by __________ times, when the number of tube passes is increased to 8....
MCQ->In this section,each passage consists of 6 sentences.The first and sixth sentences are given in the beginning as S1 and S6.The middle four sentences in each are removed and jumbled up.These are labelled P,Q,R,S.You are required to find out the proper order of the sentences and mark accordingly on the answer sheet S1:At the roadside a driver will be asked to blow through a small glass tube into a plastic bag S6:The driver will be asked to go to the police station P:And if the color change did not reach the line the driver cannot be punished under the new law. Q:Inside the tube are chemically treated crystals which change color if the driver has alcohol on his brreath R:But if the color change did reach the line,then the test has proved positive S:If the color change goes beyond a certainline marked on the tube then this indicates the driver is probably over the specified limit The proper sequence should be...
MCQ->Tubes are fixed to the tube sheet (a thick circular metallic plate) by the method of tube rolling and brazing (non-removable) or ferrule connection (removable). Thickness of the tube, sheet is normally __________ the outside diameter of the tube but in no case it should be less than 22 mm (7/8")....
MCQ->A torsion member is fabricated from two concentric thin tubes. At the ends, the tubes are welded to rigid discs so that both the tubes are twisted as a unit. The radius of the outer tube is 2r and that of the inner tube is r. If the shear stresses developed in the outer tube is τ, then the shear stress in the inner tube will be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution