1. A coil of insulated wire bound on a rod shaped form made of solid iron is called?

Answer: Solenoid

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->A coil of insulated wire bound on a rod shaped form made of solid iron is called?....
QA->A magnet made by binding insulated copper wire over a soft iron piece and passing an electric current through the wire is called?....
QA->A steel wire when bent in the form of a square encloses an area of 121 sq. cm. If the same wire is bent into the form of a circle, the area of the circle is—....
QA->Transformers, Microphones, Induction coil, Generators, Motors, Induction coil work on the principle of?....
QA->A charge of current in neighbouring coil will induce (contribute) a voltage (emf) in a coil is termed as?....
MCQ->A long iron rod initially at a temperature of 20°C has one end dipped in boiling water (100°C) at time, t = 0. The curved surface of the rod is insulated so that heat conduction is one dimensional in the axial direction. The temperature at a distance 100 mm from the dipped end becomes 40°C at time, t = 200 s. The same temperature is achieved at a distance of 200 mm from the dipped end at time...
MCQ->When a current flows through a coil of insulated wire, the coil shows the properties of a magnet....
MCQ->A 600 mm long and 50 mm diameter rod of steel (E = 200 GPa, α = 12 x 10-6/°C) is attached at the ends to unyielding supports. When the temperature is 30°C there is no stress in the rod. After the temperature of the rod drops to - 20°C, the axial stress in the rod will be...
MCQ->A rod shown in the given figure is such that the lower part is made of steel and the upper part is made of copper. Both the ends of the rod are rigidly clamped. If an axial force P is applied at the junction of the two metals, given that the ratio Esteel/ECopper is equal to 2, then the force in the copper rod would be ...
MCQ->Consider the following statements : In solid waste management 1. density separation of solid wastes can be accomplished by air classifiers. 2. iron recovery from solid wastes can be done by magnetic separators. 3. aluminium separation from solid wastes can be accomplished by eddy current separators. Which of the statements given above are correct ?...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution