Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
Match the following : a. Acrylic 1. Melt spinning b. Kevla 2. Wet spinning c. PET 3. Dry spinning d. Triacetate 4. Dry-Jet wet spinning ?->(Show Answer!)
Question Set

1. Match the following : a. Acrylic 1. Melt spinning b. Kevla 2. Wet spinning c. PET 3. Dry spinning d. Triacetate 4. Dry-Jet wet spinning





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Name India's first self-made fighter jet which received the final operational clearance for induction into the air force as a fully-weaponised fighter jet?....
QA->Which is the chief characteristic of wet and dry tropics?....
QA->Which is the chief characteristics of wet and dry tropics?....
QA->Melt ?....
QA->The snow on the mountains does not melt all at once when it is heated by the sun. Why?....
MCQ->Match the following : a. Acrylic 1. Melt spinning b. Kevla 2. Wet spinning c. PET 3. Dry spinning d. Triacetate 4. Dry-Jet wet spinning....
MCQ->Melt spinning of polymers involves the forcing of polymer melt through spinnerettes (fine holes) into an atmosphere kept at a temperature lower than the melting point of the polymer, which causes the fine diameter polymer melt to harden into filaments. Melt spinning is not used in case of the __________ fibres.....
MCQ->A jet of water,of cross sectional area 005m2 strikes a flat plate normally with a velocity of 15m/s.If the plate is moving with a velocity of 5 m/s in the direction of jet and away from the jet,What is the force exerted by the jet on the plate?....
MCQ->A jet of water strikes a flat plate with a velocity of 20 m/s inclined at 300 with the axis of the jet.If the cross-sectional area of the jet is 50 cm2 and density of water is 1000 kg/cu.m,the force exerted by the jet on the plane will be:....
MCQ->In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution