Question Set

1. In order to ensure effective cooling of each cylinder of the engine is surrounded by:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The common firing order of six cylinder engine is:....
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->The ratio between the radius of the base and the height of a cylinder is 2 : If its volume is 1617 cm3, the total surface area of the cylinder is—....
QA->There are 50 students in a class. In a class test 22 students get 25 marks each, 18 students get 30 marks each. Each of the remaining gets 16 marks. The average mark of the whole class is :....
QA->.The most effective air cleaner in case of diesel engine is:....
MCQ->In order to ensure effective cooling of each cylinder of the engine is surrounded by:....
MCQ->If p1, is the pressure of air entering the L.P. cylinder and p2 is the pressure of air leaving the L.P. cylinder (or intercooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D1 = Dia. of L.P. cylinder, and D2 = Dia. of H.P. cylinder)....
MCQ->In a compound steam engine, the first stage of expansion is carried out in a high pressure cylinder whereas the last expansion is completed in low pressure cylinder. The diameter of high pressure cylinder is __________ the lowpressure cylinder.....
MCQ->A long cylinder and a sphere both of 5 cms diameter are made from the same porous material. The flat ends of cylinder are sealed. Both the cylinder and sphere are saturated with the same solution of sodium chloride. Later both the objects are immersed for a short and equal interval of time in a large tank of water which is well agitated. The fraction of salt remaining in the cylinder and the sphere are Xc and Xs respectively. Which of the following statement is correct ?....
MCQ->A compound cylinder with inner radius 50 mm and outer radius 70 mm is made by shrinking one cylinder on to the other cylinder, The junction radius is 60 mm and the junction pressure is 1.1 N/mm2. The maximum hoop stress developed in the inner cylinder is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution