Question Set

1. Pin marking is used for-------------process.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->PIN number എന്നതിൽ PIN ന്റെ പൂർണരൂപം....
QA->A passage marking the close of a speech....
QA->The temperature for the Haber process is 500° C Catalyst used in Haber process?....
QA->Who is the inventor of Safety Pin?....
QA->The last three digits of a PIN code represent?....
MCQ->This question consists of an information and two statements numbered I and II given below it. You have to decide which information and decide which of the given statements weakens(s) or strengthen(s) the given information and decide the appropriate answer. Information : Examination committee of college X has recommended that the negative marking in the exam should be removed. I. The students tend to give answers simply by guessing when there is no negative marking in the exam. II. Selecting the best candidates from the population becomes difficult in the absence of negative marking.....
MCQ->For initial surveys of tunnels, the following activities are involved: 1. Marking portal point with concrete pillars on the ground 2. Marking tunnel obligatory points on the topographical maps 3. Preliminary setting of the tunnel on the topographical Survey of India maps 3. Driving lines between the fixed obligatory points. The correct sequence of the activities is :....
MCQ->Pin marking is used for-------------process.....
MCQ->The two links OA and OB are connected by a pin joint at O. If the link OA turns with angular velocity ω1 rad/s in the clockwise direction and the link OB turns with angular velocity ω2 rad/s in the clockwise direction, then the rubbing velocity at the pin joint O is (where r = Radius of the pin at O)....
MCQ->The two links OA and OB are connected by a pin joint at O. If the link OA turns with angular velocity ω1 rad/s in the clockwise direction and the link OB turns with angular velocity ω2 rad/s in the anti-clockwise direction, then the rubbing velocity at the pin joint O is (where r = Radius of the pin at O)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution