Question Set

1. In working profile of a longitudinal section,the depth of cuttings are written in:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A can complete a work in 12 days with a working of 8 hours per day. B can complete the same work in 8 days when working 10 hours a day. If A and B work together, working 8 hours a day, the work can be completed in --days.....
QA->If in a code language PRINCIPAL is written as MBOQSOMVW and TEACHER is written as FDVSZDB, how is CAPITAL written in that code ?....
QA->Moho discontinuity lies at the depth of approximately how many kilometers?....
QA->Which is the greatest known ocean depth (which lies in the Pacific Ocean)?....
QA->Moho discontinuity lies at the depth of approximately howmany kilometers?....
MCQ->In working profile of a longitudinal section,the depth of cuttings are written in:....
MCQ->In the case of S2 water surface profile (y = depth of flow, y0 = normal depth, yc = critical depth)....
MCQ->At a cross-section of a beam, the maximum compressive stress at top is 800 kg/cm2 and its maximum tensile stress at bottom is 200 kg/cm2. The depth of cross-section is 10 cm. The depth of the neutral axis from the top of the section is n. The n is equal to....
MCQ->Consider the following statements regarding the working stress design of under-reinforced RC sections: 1. The neutral axis depth will be greater than that of a balanced section 2. The stress in steel in tension will reach its maximum permissible value first 3. The moment of resistance will be less than that of the balanced section 4. The concrete on'the tension side is also to be considered for calculating the moment of resistance of the section. Of these statement :....
MCQ->A mild steel bar of square cross-section 40 mm x 40 mm is 400 mm long. It is subjected to a longitudinal tensile stress of 440 N/mm2 and lateral compressive stress is 200 N/mm2 in perpendicular directions. E = 2 x 10-5 N/mm2, μ = 0.3. What is the approximate elongation of tht bar in the longitudinal direction ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution