Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
Cold cracking in the heat affected zone of a high strength steel weld can take place because of the ?->(Show Answer!)
Question Set

1. Cold cracking in the heat affected zone of a high strength steel weld can take place because of the





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Raj can do a piece of work in 5 hours. Hari and Siva can do it in 3 hours. Raj and Siva can do it in 4 hours. How long will Hari take to do it ?....
QA->Raj can do a piece of work in 5 hours. Hari and Siva can do it in 3 hours. Raj and Siva can do it in 4 hours. How long will Hari take to do it ?....
QA->If a stay order has been granted by the High Court in a case, the application of the affected party by such an order shall be disposed of by the High Court within a period of?....
QA->P can do a work in the same time in which Q and R together can do it. If P and Q work together, the work can be completed in 10 days. R alone needs 50 days to complete the same work. then Q alone can do it in....
QA->Stainless Steel ഉണ്ടാക്കാൻ Steel ൻ്റെകുടെ ചേർക്കുന്ന ലോഹം....
MCQ->Cold cracking in the heat affected zone of a high strength steel weld can take place because of the....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->The strength of single fillet weld,having length of weld 1,weld size s and permissible stresses is:....
MCQ->The tensile strength of the welded joint for double fillet is (where s = Leg or size of the weld, l = Length of weld, and σt = Allowable tensile stress for weld metal)....
MCQ->The strength of single fillet weld,having length of weld 1,weld size s and permissible stress s is:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution