Question Set

1. The tensile strength of the welded joint for double fillet is (where s = Leg or size of the weld, l = Length of weld, and σt = Allowable tensile stress for weld metal)





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Heating rubber with sulphur for the betterment of its properties like tensile strength; hardness; elasticity etc. is called as?....
QA->In a bid to fill the vacant seats in trains and meet the challenges posed by the roadways and airways, the Indian Railways has decided to give discount of up to __________ to passengers on ticket fares in air-conditioned executive class and chair cars of trains like Shatabdi Express, Gatiman Express, Tejas Express, Double Decker and Intercity Express.....
QA->The length and breadth of a rectangular field in the ratio of 12: 7 . Find the length if area of the field is 52,500 Sq.m?....
QA->The ratio of length and breadth of a rectangle is 7: if perimeter is 52 then, what is the length of the rectangle?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
MCQ->The tensile strength of the welded joint for double fillet is (where s = Leg or size of the weld, l = Length of weld, and σt = Allowable tensile stress for weld metal)....
MCQ->What will be the output of the following program? #include<iostream.h> double BixFunction(double, double, double = 0, double = 0, double = 0); int main() { double d = 2.3; cout<< BixFunction(d, 7) << " "; cout<< BixFunction(d, 7, 6) << endl; return 0; } double BixFunction(double x, double p, double q, double r, double s) { return p +(q +(r + s x) x) x; }....
MCQ->The permissible stress in the fillet weld is 100 N/mm2. The fillet weld has equal leg lengths of 15 mm each. The allowable shearing load on the weldment per cm length of the weld is....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Shear strength of the welded joint for double parallel fillet is (where τ = Allowable shear stress for weld metal)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution