Compressed dry air is used as the cutting fluid, while machining ?->(Show Answer!)

Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
Compressed dry air is used as the cutting fluid, while machining ?->(Show Answer!)

Question Set

1. Compressed dry air is used as the cutting fluid, while machining

Ask Your Doubts Here

Comments

Show Similar Question And Answers

QA->The process of transfer of heat from one point of a fluid to another part of a fluid by the movement of fluid itself is called?....

QA->Most fish do not sink in water because of the presence of: swim bladder; air bladder; air sacs; air in spongy bones?....

QA->Energy stored in a compressed string is?....

QA->Which allotrope of the carbon is used in cutting and drilling?....

QA->What material is used for cutting glass?....

MCQ->Compressed dry air is used as the cutting fluid, while machining....

MCQ->In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is....

MCQ->Bernoulli's equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli's equation ? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible.....

MCQ->At equilibrium the concentration of water in vapour phase (C)in kg/m3 of air space and the amount of water (m) adsorbed per kg of dry silica gel are related by, C = 0.0667m. To maintain dry conditions in a room of air space 100m3 containing 2.2 kg of water vapour initially, 10 kg of dry silica gel is kept in the room. The fraction of initial water remaining in the air space after a long time (during which the temperature is maintained constant) is....

MCQ->No cutting fluid is normally used, while machining....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution