Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
Oxide layer formed on the non-ferrous metal surface after its annealing is ?->(Show Answer!)
Question Set

1. Oxide layer formed on the non-ferrous metal surface after its annealing is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which is a non-ferrous metal?....
QA->Aluminium surface are often ‘anodized’. This means deposition of a layer of which oxide?....
QA->Ferrous oxide gives which colour to glass?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->The process in which a liquid changes into its vapour from its surface at a temperature below its boiling point is called?....
MCQ->Oxide layer formed on the non-ferrous metal surface after its annealing is....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->A metal oxide is reduced by heating it in a stream of hydrogen. After complete reduction, it is found that 3.15 gm of the oxide has yielded 1.05 gm of the metal. It may be inferred that the....
MCQ->Consider the following statements: The function of oxide layer in an IC device is to mask against diffusion or non implantinsulate the surface electricallyincrease the melting point of siliconproduce a chemically stable protective layer Of these statements:....
MCQ->The ferrous metals require more machining allowance than non-ferrous metals.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution