Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
Yield strength of a polycrystalline metal with an average grain size, d, is proportional to ?->(Show Answer!)
Question Set

1. Yield strength of a polycrystalline metal with an average grain size, d, is proportional to





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The average salary of all the workers in a workshop is Rs. The average salary of 7 technicians is Rs.12000 and the average salary of the rest is Rs. How many workers are there in the workshop ?....
QA->The average of six numbers is x and the average of three of these is y. If the average of the remaining three is z, then....
QA->The average score of a cricketer for ten matches is 9 runs. If the average for the first six matches is 42, what is the average for the last four matches?....
QA->In trial average method, the average of 20 numbers is assumed to be The sum of deviations of the numbers from 24 is found to be What is the average?....
QA->The average monthly income of A and B is Rs. The average monthly income of B and C is Rs. 6250 and the average monthly income of A and C is Rs. What is the monthly income of A?....
MCQ->Yield strength of a polycrystalline metal with an average grain size, d, is proportional to....
MCQ->Elastic failure of a material occurs, when the tensile stress equals yield strength, yield point or the elastic limit. Also, the elastic failure occurs according to maximum strain theory, when the maximum tensile strain equals (where, σ = yield strength and E = modulus of elasticity)....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Which of the following statements are correct about the C#.NET code snippet given below? int[ , ] intMyArr = {{7, 1, 3}, {2, 9, 6}}; intMyArr represents rectangular array of 2 rows and 3 columns. intMyArr.GetUpperBound(1) will yield 2. intMyArr.Length will yield 24. intMyArr represents 1-D array of 5 integers. intMyArr.GetUpperBound(0) will yield 2.....
MCQ->The orientation polarization is directly proportional to temperatureinversely proportional to temperatureinversely proportional to square of permanent dipole momentdirectly proportional to square of permanent dipole moment. Which of the above are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution