Question Set

1. Which of the following is an organo-metal-lic compound ?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Chlorophyll is a naturally occuring chelate compound in; what is the which the central metal in this?....
QA->Chlorophyll is a naturally occuring chelate compound in, what is the which the central metal in this?....
QA->Chlorophyll is a naturally occurring chelate compound in which central metal is?....
QA->A man borrowed Rs. 5000 at the rate of 20% compound interest. Calculate the compound interest at the end of 3 years.....
MCQ->Which of the following is an organo-metal-lic compound ?....
MCQ->കോ -ബ്രാൻഡഡ് രൂപ പേ ക്രെഡിറ്റ് കാർഡുകളുടെ രണ്ട് വകഭേദങ്ങൾ – LIC CSL ‘ലൂമിൻ’ പ്ലാറ്റിനം ക്രെഡിറ്റ് കാർഡ് LIC CSL ‘ ഇക്ലേറ് ‘ എന്നിവ LIC CSL താഴെ പറയുന്ന ഏത് ബാങ്കുമായി ഒന്നിച്ചാണ് സമാരംഭിക്കുന്നത്?....
MCQ->കോ -ബ്രാൻഡഡ് രൂപ പേ ക്രെഡിറ്റ് കാർഡുകളുടെ രണ്ട് വകഭേദങ്ങൾ – LIC CSL ‘ലൂമിൻ’ പ്ലാറ്റിനം ക്രെഡിറ്റ് കാർഡ് LIC CSL ‘ ഇക്ലേറ് ‘ എന്നിവ LIC CSL താഴെ പറയുന്ന ഏത് ബാങ്കുമായി ഒന്നിച്ചാണ് സമാരംഭിക്കുന്നത്?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Pick out thể one word for - a secret arrangement....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution