Question Set

1. In a dry packed bed, the pressure drop will be changed by increasing the flow rate as





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Water evaporates at atmospheric pressure at a certain rate. If now the some water is placed in vaccum. The rate of evaporation?....
QA->Which body was established on 12th July 1982 by a special act by the Parliament with the purpose to uplift rural India by increasing the credit flow for elevation of agriculture & rural non farm sector?....
QA->On a clean glass plate a drop of water spreads to form a thin layer whereas a drop of mercury remains almost spherical because?....
QA->The default lines to drop for Drop cap is ______....
QA->The default lines to drop for drop cap is:....
MCQ->In a dry packed bed, the pressure drop will be changed by increasing the flow rate as....
MCQ->In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is....
MCQ->At the same gas flow rate, the pressure drop in a packed tower being irrigated with liquid __________ that in dry packed tower.....
MCQ->Bed pressure drop in an air fluidised bed of catalyst particles (ρp = 200 kg/m3, Dp = 0.05 cm) of 60 cm bed depth and bed porosity of 0.5 expressed in cm of water (manometer) is....
MCQ->A bed of spherical particles (specific gravity 2.5) of uniform size 1500 μm is 0.5 m in diameter and 0.5 m high. In packed bed state, the porosity may be taken as 0.4. Ergun's equation for the above fluid-particle system (in SI units) is given below : Δ P/L = 375 x 103 VOM + 10.94 x 106 V2OM (SI units) If water is to be used as the fluidising medium, in actual operation, the above bed has a height = 1 m. What is the porosity of the fluidised bed ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution