Question Set

1. Tar yield in the low temperature and high temperature carbonisation of dry coal may be respectively __________ percent.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->It is easier to roll a barrel full of coal tar than to pull it because?....
QA->Present ages of Kiran and Syam are in the ratio of 5:4 respectively. Three years hence, the ratio of their ages will become 11:9 respectively. What is Syam"s present age in years?....
QA->Present ages of Kiran and Syam are in the ratio of 5 : 4 respectively. Three years hence, the ratio of their ages will become 11 : 9 respectively. What is Syam"s present age in years?....
QA->___ may by law constitute a High Court for a Union Territory or declare any court in any such Territory to be a High Court.?....
QA->.Arcelor​ ​Mittal,on​ ​June​ ​23,2008,signed​ ​an​ ​agreement​ ​to​ ​acquire​ ​the Mid​ ​Vol​ ​Coal​ Group,located​ ​in​ ​southwestern- in​ ​the​ ​Central Appalachian​ ​coal​ ​basin​ ​of​ U.S.​ ​with​ ​estimated​ ​reserve’s​ ​and​ ​resources in​ ​excess​ ​of​ ​85​ ​million​ ​tones.....
MCQ->Tar yield in the low temperature and high temperature carbonisation of dry coal may be respectively __________ percent.....
MCQ->The yield of tar from high temperature carbonisation of dry coal is about __________ percent.....
MCQ->Yield of coke oven gas in low temperature carbonisation of coal is about __________ Nm3 /ton of dry coal.....
MCQ->In low temperature carbonisation of coal as compared to high temperature carbonisation __________ produced is less.....
MCQ->In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution