Question Set

1. In reverberatory furnace, charge is heated mainly by





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The inventor of the Steel Furnace is?....
QA->The iron obtained direct from the blast furnace is called?....
QA->The charge on positron is equal to the charge on?....
QA->What does mixture of CS2 and H2 S on passing over heated copper give?....
QA->In vulcanisation; with which the natural rubber is heated?....
MCQ->In reverberatory furnace, charge is heated mainly by....
MCQ->A sphere with charge Q was placed in, but not touching a larger hollow sphere. If there is any charge initially on the outer sphere; to remove it the outer sphere was earthed momentarily, and then the inner sphere was removed. The charge remaining on the outer sphere was then measured. This charge was found to be __________ to the charge on the inner sphere.....
MCQ->Consider an arbitrary distribution of conducting bodies in a charge free space according to the uniqueness theorem, which of following are required to be specified in order that the field is uniquely determined everywhere? Total charge on each conductorPotential at each conductor surfacePotential at same of conductor and total charge on the remainderTotal charge as well as potential gradient on each conductor surface Select the correct answer using the codes given below codes....
MCQ->Reverberatory furnace is used for....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution