Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
The throttle position sensor can be checked by ?->(Show Answer!)
Question Set

1. The throttle position sensor can be checked by





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->P can do a work in the same time in which Q and R together can do it. If P and Q work together, the work can be completed in 10 days. R alone needs 50 days to complete the same work. then Q alone can do it in....
QA->The work done by one staff is automatically checked by another is called....
QA->P,Q and R together earn Rs.1620 in 9 days. P and R can earn Rs.600 in 5 days. Q and R in 7 days can earn Rs. How much amount does R can earn per day?....
QA->A can do a piece of work in 4 hours . A and C together can do it in just 2 hours, while B and C together need 3 hours to finish the same work. B alone can complete the work in --- days.....
QA->A and B can do a work in 10 days, B and C can do it in 12 days, C and A can do it in 15 days. If A, B, and C work together, they will complete the work in:....
MCQ->The throttle position sensor can be checked by....
MCQ->Refer the given figure. The outputs (Q0–Q3) of the memory are always LOW. The address lines (A0–A7) are checked with a logic probe and all are indicating pulse activity, except for A3, which shows a constant HIGH, and A7, which shows a constant LOW; the select lines, are checked and shows pulse activity, while indicates a constant HIGH. What is wrong, and how can the memory be tested to determine whether it is defective or if the external circuitry is defective?

....
MCQ->Pick out thể one word for - a secret arrangement....
MCQ->If the steel disk in a crankshaft position sensor has stopped with the tab in the magnet's air gap, the induced voltage....
MCQ->Consider the following statements regarding a simply supported beam subjected to a uniformly distributed load over the entire span : 1. The bending moment is maximum at the central position. 2. The shear force is zero at the central position. 3. The slope is maximum at the middle position. Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution