Question Set

1. Silicon percentage in iron castings to have maximum hardness should be about





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->‘I have been touring different parts of the world. During these travels, I have had the good fortune to come into contact with several saints and maharshis. But I have frankly to admit that I have never come across one who is spiritually greater than Swami Sree Narayana Guru of Kerala” Whose words are these?....
QA->If 10 percentage of 100 is equal to X percentage of 50, then the value of X is ________.....
QA->“During my travels throughout the world, I have had the good fortune to come in contact with several saints and maharishis... But I have frankly to admit that I have never come across one who is spiritually greater than Swami Narayana Guru or a person who is at par with him in spiritual attainment.” Who paid tribute in the above words after visiting Sree Narayana Guru?....
QA->When an iron nail gets rusted, iron oxide is formed?....
QA->District with maximum forest area in percentage....
MCQ->Silicon percentage in iron castings to have maximum hardness should be about....
MCQ->Straight silicon steel (containing Si from 0.5 to 5%) because of their low hysterisis loss and high magnetic permeability are used for electrical appliances. Which of the following electrical appliances made of silicon steel contains maximum percentage of silicon (about 4%) ?....
MCQ->Silicon is doped with boron to a concentration of 4 x 1017 atoms/cm3. Assuming the intrinsic carrier concentration of silicon to be 1.5 x 1010/cm3 and the value of to be 25mV at 300K. Compared to undoped silicon, the Fermi level of doped silicon....
MCQ->If an aluminium pattern made from a wooden master pattern is to be used for grey iron castings, then the shrinkage allowance allowed on the wooden pattern should be....
MCQ->Which of the following pairs are correctly matched ? 1. Alpha iron....non magnetic 2. Beta iron....strongly magnetic 3. Gamma iron....non-magnetic and capable of dissolving carbon. 4. Delta iron....non-magnetic and absorbs very little carbon. Select the correct answer using the codes given below :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution