Question Set

1. Which of the following reactors is operated at high neutron flux and low power level ?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The economic condition in which the rate at which the general level of prices for goods and services is rising and subsequently; purchasing power is falling is called?....
QA->Who among the following developed the high level language FORTRAN?....
QA->Which type of clouds is a low level cloud?....
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
QA->What is termed as the period of high inflation and low economic growth?....
MCQ->Which of the following reactors is operated at high neutron flux and low power level ?....
MCQ->A moderator, apart from its high neutron slowing power, and low non-productive neutron, should be....
MCQ->For a logic family VOH is the minimum output high level voltage VOL is the maximum output low level voltageVIH is the minimum acceptable input high level voltageVIL is the maximum acceptable input low level voltage The correct relationship is....
MCQ->An 8 bit transistor register has output voltage of low-high-low-high-low-high-low-high. The decimal number stored is....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution