Question Set

1. Transistor parts and refrigerator components are normally made of





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A cold bottle is taken from a refrigerator and weighed. As time progresses we will find?....
QA->Dr Ambedkar had said that Article ___ should normally remain a 'dead letter' and would be used only in the 'last resort'.?....
QA->Dr. Ambedkar had said the "Article ___ should normally remain a 'dead letter' and would be used only in the 'last resort'.?....
QA->Who is the inventor of Transistor?....
QA->Three regions of a transistor?....
MCQ->Transistor parts and refrigerator components are normally made of....
MCQ->__________ is normally used for the manufacture of refrigerator components and transistor parts.....
MCQ->In the following question the 1st and the last part of the sentence/passage are numbered 1 and 6. The rest of the sentence/ passage is split into four parts and named P, Q, R and S. These four parts are not given in their proper order. Read the sentence/ passage and find out which of the four combinations is correct. 1. Making ropes is one of the oldest trades in the world.P. People used them for tethering animals, for drawing water from wells and for dragging large stones which were used in building.Q. We know that people made ropes several centuries back.R. They made them from camel hair and from twisted grass.S. We have found pieces of rope in very old Egyptian tombs.6. We have found too, ropes which were made of thin copper wire in the city of Pompeii, which was destroyed by a volcano 2000 years ago.....
MCQ->A mild steel bar is in three parts, each 20 cm long. The diameters of parts AB, BC and CD are 2 cm, 1 cm and 3 cm respectively. The bar is subjected to an axial pull of 4t as shown in the given figure. If E = 2 x 106 kg/cm2 and the elongations in the three parts of the bar are Δ1, Δ2 and Δ3 respectively, then the ratio of the greatest to the least of these elongations will be

....
MCQ->The thermal efficiency of a reversible heat engine operating between two given thermal reservoirs is 0.4. The device is used either as a refrigerator or as a heat pump between the same reservoirs. Then the coefficient of performance as a refrigerator (COP)R and the co-efficient of performance as a heat pump (COP)HP are....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution