Question Set

1. __________ is normally used for the manufacture of refrigerator components and transistor parts.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In a bid to fill the vacant seats in trains and meet the challenges posed by the roadways and airways, the Indian Railways has decided to give discount of up to __________ to passengers on ticket fares in air-conditioned executive class and chair cars of trains like Shatabdi Express, Gatiman Express, Tejas Express, Double Decker and Intercity Express.....
QA->Union Minister of State for Power and New and Renewable Energy (IC) and Skill Development and Entrepreneurship, RK Singh approved a proposal to declare __________ as Renewable Energy.....
QA->Dr Ambedkar had said that Article ___ should normally remain a 'dead letter' and would be used only in the 'last resort'.?....
QA->Dr. Ambedkar had said the "Article ___ should normally remain a 'dead letter' and would be used only in the 'last resort'.?....
QA->Which chemical is used in a refrigerator for cooling purposes?....
MCQ->__________ is normally used for the manufacture of refrigerator components and transistor parts.....
MCQ->Transistor parts and refrigerator components are normally made of....
MCQ->Pick out thể one word for - a secret arrangement....
MCQ->The thermal efficiency of a reversible heat engine operating between two given thermal reservoirs is 0.4. The device is used either as a refrigerator or as a heat pump between the same reservoirs. Then the coefficient of performance as a refrigerator (COP)R and the co-efficient of performance as a heat pump (COP)HP are....
MCQ->A mild steel bar is in three parts, each 20 cm long. The diameters of parts AB, BC and CD are 2 cm, 1 cm and 3 cm respectively. The bar is subjected to an axial pull of 4t as shown in the given figure. If E = 2 x 106 kg/cm2 and the elongations in the three parts of the bar are Δ1, Δ2 and Δ3 respectively, then the ratio of the greatest to the least of these elongations will be

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution